Rhythmic Robot – Bass III (KONTAKT)

By | September 15, 2024

 

Manufacturer : Rhythmic Robot
Format : KONTAKT.NKI.NCW
Quality : 24 bit Frequency: 44.1 kHz Channels: stereo


Description : Bass III offers the sound of the monophonic analog synthesizer Hohner Bass 3. All three preset patches of the original device (Guitar, String and Tuba) are presented. In addition, additional features have been added: full ADSR control, effects, a speaker simulator, a tube saturator. There is also an additional patch called “All Buttons Out”, which combines all three original patches.

Now this little thing is funky! The Hohner Bass 3 was an all-analogue minisynth that produced three preset bass tones: Guitar, String and Tuba. Don’t let the names fool you: this isn’t orchestral, nor is it folky. It’s just raw and wild: a thunky twang gives the Guitar patch its bite, the String setting is all low tone for instant depth, and the Tuba is snarly with a ton of overtones to help it cut through a mix (or to be low- pass filtered to get even more scope). It all came packaged in a little black leatherette suitcase that you could close up to take on the road; and opened, it could be perched atop your Rhodes on stage so you could riff with your right and hold down the bass with your left. It was like opening up a neat little package and finding the Biggest Sound In The World was hiding inside.
It was quirky, too. The two rotary controls on the panel were for volume (on the left) and a kind of weird envelope thing on the right. Twisting the right-hand control gave you either long sustained notes or short bass bops. And that, apart from preset selection, was it. Not a fat lot of versatility, to be honest. Naturally we’ve bolted some bits on to take care of that: our take on the Bass 3 has a full envelope control slotted in under the Preset buttons, and gives over the two rotary controls to Tone (which is a gentle low-pass filter ) and Vibrato depth. There are further Rate and Delay controls for the Vibrato on the rear panel, which also has effects bays for Chorus and Phaser and Tube saturation to give the sounds a hotter edge. Rounding things off round the back are a mono/poly switch with portamento (glide) control, a stereo spread knob, and a full selection of amp cabinets through which to run your bass tones. These can really bring the Bass III to life.

As well as adding in effects, we’ve also allowed you to do something that was impossible on the original instrument: to select all three Presets simultaneously. This gives you a really complex sound that takes the depth of the Guitar preset and adds a hefty dose of the Tuba’s overtones to it to create a real monster of a patch. To get it, just select a Preset button and then click it again to “pop it out”: with all three buttons out, you’ll get our Bass III all-at-once patch.

Our Bass 3 exhibits a fair amount of “analogue drift”, which we’ve partially cleaned up but partially left in place. The result is a stable, properly tuned bass synth that nevertheless has enough warmth to its sounds that it’s going to add some serious analogue mojo to the underpinnings of your tracks.

The Bass III doesn’t cover every bass sound under the sun: it just does three sounds (plus that hidden fourth) really really well. Plus it’s unusual and it’s analogue through and through. Bass III – time to go down!



Leave a Reply